How to unclog a toilet fast | No Nasty Hands

Clogged toilets are a nuisance for any home or business. If you’re a homeowner, there’s a good chance you’ve always experienced clogging toilets, especially on a busy morning. 

If your toilet is clogged, there’s no need to panic! In most cases, you can unclog it yourself in just a few minutes before calling a plumber.

I’ll guide you on how to unclog a toilet quickly. I’ll also show you how to avoid clogs in the first place. Keep reading for more information.

How to Unclog A Toilet Fast 

If your toilet is clogged and you need to unclog it fast, there are a few things you can do. There are several methods for unclogging a bathroom, but the most frequent is to use a plunger.

To use this technique, you will need: – A bucket or bowl large enough that the plunger can fit inside of it and still have room for water (a clean sink) – Water from your faucet – The plunger itself (obviously) 

1. If you don’t already have your plunger, go outside to the nearest available plumbing fixture (such as a toilet). Lift the lid and empty the bowl of its contents. 

2. The next step is to fill your bucket or sink with water from your faucet. The water should be high enough to cover the plunger. 

3. Next, close the lid and fill the bowl with sink water from your faucet. 

4. Plunge up and down to create suction which will pull the clog out of your toilet 

5. The water should start going down. Pour it into the toilet and plunge a few more times to remove whatever is left of your clog.

6. If you’re successful, congratulations!

If you’re not, don’t give up yet. It may take a few tries or require going to a professional.

However, there are other options if you feel up to it. Here they are 

1. Try using hot water instead. Sometimes cold water won’t work as well 

2. You can also try boiling a gallon of water and pouring it into the toilet to melt the clog 

3. If that doesn’t work, you can try adding dish soap or laundry detergent to your water. The chemicals in these may help 

4. Finally, you can also try pouring a gallon of hot boiling water down your drain, followed by a gallon of cold water.

If you use a plunger to unclog your toilet, the plunger must be the correct size. If the plunger is too large or small, it will not make a tight seal and won’t create the suction needed to pull out the clog. 

You can find out if your plunger is the right size by filling up the bowl with water and submerging the plunger in it. It is too small if the plunger stays on top of the water without sinking to the bottom. 

If the plunger sinks to the bottom, it is too large. You can also try plunging at a downwards 45-degree angle instead of up and down to see if it creates suction by itself.

A plunger uses a flange, which attaches to the bottom of the plunger and makes it easier to create suction by creating a better seal.

A plunger with a wedge is used when the toilet bowl is especially deep. The wedge helps keep the plunger’s head at the bottom of the bowl.

Snake it

Toilet augers, also known as a closet augers, are long flexible snakes with a handle with a crank at the end. 

To use this technique, you will need: – A bucket or bowl large enough that the auger can fit inside of it and still have room for water (a clean sink) – A toilet plunger (duh)

1. If you don’t already have your auger, go outside to the nearest available plumbing fixture (such as a toilet). Empty the bowl of its contents.

2. Next, fill your bucket or sink with water. The water should be high enough to cover the auger.

3. Close the lid and fill the bowl with your sink water.

4. The next step is to plunge up and down while cranking the handle to create suction which will pull the clog out of your toilet. You may require to repeat this step a few times to be effective.

5. The water should start going down. Pour it into the toilet and plunge a few more times to remove whatever is left of your clog.

First, try using a plunger. If that doesn’t work, you can try pouring a bucket of water into the toilet to flush it out. 

If that still doesn’t work, you can try using a snake to clear the clog. If that still doesn’t work, get ready to use a homemade drain cleaner.

Homemade Drain Cleaner Recipe Here is an excellent recipe for a homemade drain cleaner:

– 1 cup baking soda (bicarbonate of soda) – 1/2 cup salt (sodium chloride) – 1/4 cup vinegar (acetic acid) – 1/4 cup dish soap (surfactant)

Mix all of the ingredients together and pour them into the clogged drain. If you have a double sink, just pour it down one side. 

Baking soda and vinegar combine chemically to produce carbon dioxide gas, which will loosen whatever is stuck.

How do you unclog a toilet when a plunger doesn’t work?

When a plunger doesn’t work to unclog a toilet, you can try using a wet/dry vacuum

First, try to plunge the toilet as you would normally. If this doesn’t work, try adding water to the toilet bowl until it’s about half full. 

Next, connect the wet/dry vacuum to the overflow tube on the toilet. Turn the vacuum on and wait until the water level in the bowl goes down. This should remove the clog.

Read More- Will a toilet eventually unclog itself?

How to unclog a toilet fast when the bowl is full?

If you’re unfortunate enough to find yourself in a situation where the toilet bowl is full, and water is spilling over, don’t panic! 

There are various things you may do to fast unclog the toilet. This article will provide five tips for unclogging a toilet fast. 

Follow these tips, and you’ll have your bathroom back to normal in no time.

1. Pour a water pitcher straight into the bowl from waist level. Although you may be tempted to pour a gallon of water directly into the bowl, this is not recommended. If the water doesn’t flow past the clog immediately, or if you splash water onto the floor, you’ll have a bigger mess to clean up.

2. Pour liquid dish soap into the bowl. When you pour dish soap into the toilet, it unclogs the toilet because it acts as a lubricant between the clog and the water. This trick works especially well for liquid and gel dish soaps. If you don’t have any dish soap around, you can use shampoo or hand soap instead.

3. Pour a combination of baking soda and vinegar down the toilet. Baking soda will help break up the clog if your home has a septic tank. At the same time, the vinegar will neutralize any odors caused by baking soda.

4. Pour a bucket of hot water into the bowl. This will flush the clog down the drain. If this doesn’t work, try adding a little bit of dish soap or shampoo to the water.

5. Create a plunger solution with baking soda and vinegar and pour it down the toilet. Just like in Tip #3, the baking soda will break up the clog, and the vinegar will neutralize any odors caused by the baking soda.

After you’ve followed these tips, try flushing the toilet again. If it still doesn’t work properly, you may have to call a plumber. 

You can also read our article on unclogging a toilet with muriatic acid for other tips.

How to unclog a toilet without a plunger that is overflowing?

There are a few ways to unclog a toilet without a plunger when it is overflowing. 

One way is to use a wet/dry vac. Another way is to use dish soap. 

Another way is to use a bucket or use a coat hanger.

If you’re out of options, here’s how to use a coat hanger:

-Unhook the bottom part of your toilet chain from the chain holder/handle thing.

-To do this, grasp the small metal circle that connects the chain to the handle and push it into the handle until you hear a click. 

Pull gently to remove it from the handle, being careful not to pull too hard, so you don’t break the handle (if you break the handle/chain connection, it’s an annoying and tedious job to replace).

-Take your coat hanger and make it straight. You will want to use the wire part, not the hook part.

-Feed the straight end of your hanger through the bottom part of your toilet chain at least a foot. The more distance you can get, the better.

-Once you have it fed through the chain, curve it back towards you. This is where you will need to be creative. Use a strong grasp and pull with full strength.

-After it’s unclogged (you will hear water rushing through), wipe the area with a dry towel and flush. It should be much better now…If not, repeat the process.

how to unblock a clogged toilet fast

How to Unblock a Clogged Toilet with Paper?

1. Pour a pot of boiling water down the toilet. Sometimes hot water works like magic. It dissolves the paper so soon and unblocks your toilet. Hot water works on hair, grease, oily-fatty clogs.

2. Use a plunger to try to unblock the clog. A plunger is an easy tool; although many of us do not like it, plunging several times can unplug clogs created by paper, baby wipes, small toys, etc.

3. Use a closet auger to try to unblock the clog. Auger is another great plumbing tool for unclogging a toilet. It works well in solid objects like toys, retainers, paper towels, etc.

4. Insert a chemical drain cleaner into the clogged toilet, letting it sit overnight. 

5. Pour 1 cup of baking soda down the clogged toilet, followed by 1 cup of white vinegar. It’s one of the best homemade options. 

6. If the clog doesn’t clear after one attempt with a plunger, use a closet auger to clear the clog.

7. If the clog doesn’t clear after one attempt with a closet auger, use an electric eel to unblock the clog. Call a plumber if the clog doesn’t clear after one attempt with an electric eel.

8. If you still can’t clear the clog, hire a pro to replace your sewer line.

Read More- How Unclog a toilet when nothing works

Tricks and Tips to Avoid Toilet Clogging

When it comes to toilets, clogs are the biggest nuisance. They can cause overflowing and a messy bathroom, not to mention an unsanitary one. 

Here are a few ways to avoid toilet clogs:

-Make sure you don’t flush anything other than human waste and toilet paper down the toilet. Sanitary napkins, baby wipes, and other types of wipes should never be flushed.

-If you have kids, make sure they know not to flush toys or other objects down the toilet.

-Avoid putting excessive amounts of toilet paper down the drain. It’s best to fold the toilet paper instead of wadding it up.

-Don’t pour grease, oil, or fat down the drain. They can harden and create clogs in your pipes.

-If you notice that your toilet is clogging more often than usual, it may be time to clear the sewer line. 

-If your toilet is still clogging up, it may be time to call a professional plumber. The average fee of having a plumber clear a clogged toilet is $100-$150, but it’s often cheaper than the cost of dealing with the damage and problems that come with a clogged up toilet.

-If you own a home, make sure to get your sewer line inspected at least once every three years. This will help you avoid any potentially expensive issues with your sewer line in the future.

What is the best liquid to unclog a toilet?

Drano is the best liquid to unclog a toilet. Drano is a gel that is used to unclog drains. It is made of two main ingredients: sodium hydroxide and aluminum. 

When these ingredients mix with water, they create a chemical reaction that dissolves the clog.

Wrap Up on Unclog A Toilet Fast When The Bowl is Full At Home

Unblocking a toilet can be a daunting task, but with the right tools and some know-how, it can be an easy fix. In this article, we’ve outlined four methods for unblocking a toilet as well as what you need to have on hand before beginning the process. 

After reading this post, we hope that you feel confident enough to tackle the job yourself – and save yourself some money in plumbing fees!

Q1. Can Coke clear a clogged toilet?

No, Coke will not clear a heavily clogged toilet. You can read how coke and baking soda clean a nasty toilet.

Q2. What do plumbers recommend for unclog drains?

The answer is… well, to unclog drains, you should use an industrial-strength drain cleaner like Drano Gel. But if you can find a plumber with industrial-strength drain cleaner in their truck, go for it! 

It’s always best to have professionals handle your plumbing problems. You’ll save yourself unnecessary grief and money at the same time.

Leave a Comment